Several reasons why the led electronic display can not be loaded

August 11, 2020

When using a led electronic display, it often fails to load. The first LED network analyzes the reasons why the display cannot be loaded from the following aspects.

1. Check if the jumper cap is loose or fall off; if the jumper cap is not loose, please make sure that the jumper cap is in the correct direction.

2. Check that the serial cable used to connect to the controller is a straight-through cable, not a crossover cable.

3. Check and confirm that the serial port cable is intact and there are no loose or falling off at both ends.

4. Compare the LED display control software and the control card of your choice to select the correct product model, the correct transmission mode, the correct serial port number, the correct serial transmission rate, and correctly set according to the DIP switch diagram provided in the software. Controls the address bit and serial transfer rate on the system hardware.

5. Ensure that the control system hardware is properly powered.

6. If the above check and correction still does not load, please use a multimeter to measure whether the serial port of the connected computer or control system hardware is damaged. To confirm whether it should be returned to the computer manufacturer or return the control system hardware for testing.

In short, the reason why the LED display is not loaded properly may be caused by the product itself, or it may be caused by improper operation during use. As long as you think carefully or ask the manufacturer, it is easy to find the root of the problem.

Nozzle is a key part of the spraying system,Current contact nozzle should have smooth inner wall,the shape,materials and internal details.

Nozzle

Spray Nozzle,Water Nozzle,Hose Nozzle,High Pressure Nozzle

Shaoxing Tianlong Tin Materials Co.,Ltd. , https://www.tianlongspray.com