Teach you how to identify the quality of a full-color LED display

August 26, 2019

The quality of a full-color display can be signed from the following aspects:

Flatness

The surface flatness of the LED display should be within ±1mm to ensure that the displayed image is not distorted. Local protrusion or recession may cause a blind angle in the viewing angle of the display. The quality of the flatness is mainly determined by the production process.

2. Brightness and viewing angle

The brightness of the indoor full color screen should be above 800cd/m2, and the brightness of the outdoor full color screen should be above 1500cd/m2 to ensure the normal operation of the display. Otherwise, the displayed image will not be seen because the brightness is too low. The brightness is mainly determined by the quality of the LED lamp bead.

The size of the viewing angle directly determines the number of LED display audiences, so the bigger the better. The size of the viewing angle is primarily determined by the way the die is packaged.

3. White balance effect

White balance is one of the most important indicators of LED displays. In color theory, when the ratio of the three primary colors of red, green and blue is 1:4.6:0.16, pure white will be displayed. If there is a slight deviation in the actual ratio, the deviation of white balance will occur. Generally, it should be noted whether white is blue or yellow. Green phenomenon. The quality of the white balance is mainly determined by the control system of the LED display, and the lamp beads also have an effect on the color reproduction.

4. Color reduction

The redness of color refers to the reduction of color by the LED display. The color displayed by the LED display should be consistent with the color of the source to ensure the realism of the image.

5. Whether there is mosaic or dead point

Mosaic refers to the always-on or often black small four-squares appearing on the display screen. The module is necrotic. The main reason is that the quality of the connectors used in the display is not good.

The dead point refers to a single point that is always bright or often black on the LED display. The number of dead points is mainly determined by the quality of the die.

6. There are no color blocks

The color block refers to the obvious color difference between adjacent modules, and the color transition is in units of modules. The phenomenon of color block is mainly caused by poor control system, low gray level and low scanning frequency.

Four Burner Gas Cooker

Four Burner Gas Cooker,Stainless Steel Gas Stove,Ce Table Outside Gas Cooker,4 Burner Glasstop Gas Cooker

xunda science&technology group co.ltd , https://www.gasstove.be